Dual Momentary Footswitch with Latching LEDs

Dual Momentary Footswitch with Latching LEDsThis is a dual version of our popluar Momentary Footswitch with Latching LED, for when you need a dual momentary pedal but would like a latching LEDs to show if the effects you have are toggled on or off. The pedal comes with a polarity toggle switch so you can select if the momentary switching is normally open or normally closed. There are also sync buttons on the rear of the pedal which will switch the LEDs but not send a signal to the output

This is a copy of the Digitech FS3X (FS300) footswitch and will work with the relevant Digitech pedals

Strymon – The Strymon Bigsky

Amp Switch - If any of your amp’s functions (channel select or FX loop for example) are triggered by a latching footswitch connected to the tip of a 1/4” plug connection then this switch will control it

you can add a Bright Onion TRS cable to the order above

Heavy duty footswitch

The buffer is built using the TL072 op-amp which gives great results in maintaining your signal integrity

You'll need a stereo patch cable to connect the footswitch to your Red Panda pedal

The pedal can be used with the Eventide H9

The 3 gang patchbox has a top to side socket layout and is totally passive so no power required

For example if you have a delay in the pedal's loop you can use the level knobs to set the perfect level of delay and dry signal

The front two switches (wired to tip) are set at a lower height to the back switches (wired to ring) for them not to get in the way of each other

plus the GT-1000 Core and SDE-3000 pedals