3.5" OD X 6" Long

3.5" OD X 6" LongStandard aluminum intake tubing. 6063T52 alloy . 065 wall thickness. Cuts easily with a hack saw. About 1 1 2 inches on each end goes inside an intake hose (minimum 1 inch). Mill finish (as it arrives at our location from the mill after traveling on a truck and being handled several times) may have minor defects and small scratches, but no dents or major defects. Made in USA.

Same as Donaldson P123462

This reducing hump hose connects 5" OD and 4" OD intake tubes

This reducing hump hose connects 4" OD and 3-1/2" OD intake tubes

Made in USA

Special tight-weave aramid reinforcement handles more pressure and lasts longer than most other brands

This short radius 3" 90-degree intake hose is used when you need to make a tight bend when joining two 3" OD tubes

5" OD on the other

94100-0238This 45 degree silicone elbow is 2" ID it handles 350 F continuous and is perfect for intercooler/aftercooler applications

Perfect for air-to-air aftercooler systems and turbocharger connections

Recommended clamps are 94100-0288

Not approved for water

This short radius 6" 90-degree intake hose is used when you need to make a tight bend when joining two 6" OD tubes