7" ID to 5" ID - Cobra Head Reducing - Rubber

7" ID to 5" ID - Cobra Head Reducing - RubberThis reducing cobra head elbow is 7" ID on the short end and 5" ID on the long end, and has a 1 8'NPT female pipe thread on one side. Cobra head elbows are used when clearance is extremely limited, such as when an air cleaner outlet is up against a firewall. There is no other way to make a really tight bend without losing air flow. How does the cobra head make such a tight bend without increasing turbulence? Because it flares out, creating more volume

Same as Donaldson P123462

Check out our 4" ID X 7" long charge air cooler hose made just for LS and similar engines

You install it in the end of the 3" rubber elbow or hump hose

If you have the room

90HL80R7090L80R70

and then the 5-1/2" intake tube fits into the insert

Recommended clamps are 94100-0600 on the small end and 94100-0650 on the big end

This 7" 90-degree intake hose can be used any place you have two 7" OD tubes and you need to make a 90-degree bend

This 10" ID 90-degree intake hose can be used any place you need to make a 90-degree bend

and then the 6" intake tube fits into the insert

and then the 2-3/4" intake tube fits in the hole

Temp rated at 250-275F