Fry Tub Inlet/Overflow kit

Fry Tub Inlet/Overflow kitThis is a kit to be used with a 1" bulkhead and 1" and 2" PVC pipe to create an overflow for a fry grow out system. (Pipes can be SCH20 or SCH40). Consists of: An Inlet screen with 1. 5 4. 5mm holes that draws water from the bottom of the tub. A chain retaining ring to hold seahorse chains at the bottom, or a non chain holding ring that prevents fry from getting under the inlet screen. A cap that reduces drain noise. A tangential inlet sprayer that

Crystal Green

without the rings on each end

Inlet plumbing

There are two stamps that I've made dies for- One has 16 lobes and one has 14 lobes

Do not wash in a dishwasher

Sometimes you just want to hold a single frag to the glass

100 mm high)

Designed for 3" PVC pipe soap molds

that ends in a 1/2" PVC pipe for the inlet sprayer

or other mobile creatures that you want to contain to give them time to attach to rocks or gravel

or down both sides for a dual Soap Pull

Use hot-glue