E82 Silent Fan EKP PNP Cooler Kit - (2006 - 2011 BMW 1 Series)

E82 Silent Fan EKP PNP Cooler Kit - (2006 - 2011 BMW 1 Series)*The 60mm fan WILL NOT fit behind the factory seat bolstering. HOWEVER The 40mm fan WILL fit behind the factory seat bolstering. Please note that the 40mm fan option is not available for EKPM2. This kit is intended for people that have no rear seats and would like a near silent fan option. The full plug and play EKPM3 EKPM2 cooler kit is designed specifically for E82 BMW's using an EKPM3 or EKPM2 fuel pump control module. This is recommended for

We start off by taking a brand new EKMP3 and removing the stock half bridge IC fuel pump motor driver and then we replace it with a brand new genuine Infineon half bridge IC

High Temp Cabin Filter Covers are rated up to 180°C / 356°F and are recommended for top-mount single turbo setups to avoid warping or melting

then modeled to accept our 52mm or 45mm removable gauge pods to ensure a direct fit each time

The paddle shifter delete kit replaces the following paddle shifter part #'s:

Warranty information can be found on our warranty information page

Installation Video and Overview provided by Turbo Spool on YouTube

We recommend letting the primer dry and harden for at least 6 - 8 hours before wet sanding with 1000 grit sand paper

Check out his awesome channel here: https://www

receiver DME transmitter EKP

Connect the GFB-3 controller housing to the new defroster vent base and make sure the wiring and vacuum / boost tube is run through the base as well

Additionally we cannot guarantee that upgrading your EKPM3 will fix any issues you may currently have with your vehicle

A: If your gauge is a standard 52mm or 45mm diameter gauge